% Title page for a Master's thesis in Engineering, University of Pavia (English).
%
% LaTeX version of the official Word model "Frontespizio-CLM-EN_LOGO_2021.doc"
% published by the Faculty of Engineering of the University of Pavia at
% https://webing.unipv.eu/didattica/sedute-di-laurea/
% This is not an official file of the University: check the current
% instructions on that page before printing.
%
% Fill in the fields below and keep \makeunipvtitlepage right after
% \begin{document}. Compile with pdfLaTeX, XeLaTeX or LuaLaTeX.
%
% ATTENTION: the official English names of the departments are
% - Civil Engineering and Architecture Department
% (Dipartimento di Ingegneria Civile e Architettura)
% - Department of Electrical, Computer and Biomedical Engineering
% (Dipartimento di Ingegneria Industriale e dell'Informazione)
% Write the complete name in \unipvdepartment.
\documentclass[12pt,a4paper]{report}
\usepackage[T1]{fontenc}
\usepackage[utf8]{inputenc}
\usepackage[english]{babel}
\usepackage{tgtermes} % Times-like font, as in the Word model
\usepackage[a4paper,margin=2.5cm]{geometry}
\usepackage{lipsum} % dummy text for this example only
\usepackage{unipv-titlepage}
% ------------------------------------------------------------------ fields
\unipvdepartment{Department of Electrical, Computer and Biomedical Engineering}
% \unipvdepartment{Civil Engineering and Architecture Department}
\unipvdegree{Electrical Engineering}
\unipvtitle{Title of the Thesis in English}
\unipvtitleit{Titolo della tesi in italiano}
\unipvcandidate{Name Surname}
\unipvsupervisor{Prof. Name Surname}
% \unipvsupervisor{Prof. Second Name} % a second supervisor, if any
\unipvcosupervisor{Dr. Name Surname} % only if necessary; remove otherwise
% \unipvcosupervisor{Eng. Name Surname} % one line per co-supervisor
\unipvacademicyear{2025/2026}
% \unipvlogo{logo-unipv} % logo file, default logo-unipv.png
% The titles are in plain type, as in the Word model. Optional changes:
% \renewcommand*{\unipvtitlefont}{\large\bfseries} % English title
% \renewcommand*{\unipvtitleitfont}{\normalsize\itshape} % Italian title
% A department line slightly too long is scaled down (by at most 10%) to stay
% on one line; write {1} to let it wrap instead:
% \renewcommand*{\unipvmaxshrink}{0.9}
\begin{document}
\makeunipvtitlepage
\chapter{Introduction}
\lipsum[1-2]
\end{document}